laser test Runs write laser self-test. Used to verify that the laser servo is functioning correctly, and pinpoint any trouble spots. The laser test compares the current values with the previous values, if the previous values are non-zero. If the current and previous values exhibit sharp differences, then an error is generated. This allows us to evaluate laser performance over time, and determine if laser performance has changed significantly. Previously, several servo_stat parameters had non-zero default values. If the previous laser test results were set to the non-zero default values, you can expect errors to occur during the laser test, as the current and "previous" values will most likely differ significantly. You may need to run the test several times to clear all the errors, or set all of the "previous" servo_stat values to zero. Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 This command is available. Field 27-Jun-2002 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:24:53 2008 PST